Thingiverse
Printing bed calibration nut
door andElectrons
4
Downloads
5
Likes
0
Makes
I wasn't happy with the available printing bed accessories so I created my own.
The center contains a M3 thread to screw unto the printing bed leveling rods.
Close to 7 cm (2.8 inches) printed provides good grip while (un)tightening and the spokes give some feedback on how much you've rotated the piece.
This is my first openscad project. I am looking for feedback. If you have any comments, hints or suggestions let me know.
The center contains a M3 thread to screw unto the printing bed leveling rods.
Close to 7 cm (2.8 inches) printed provides good grip while (un)tightening and the spokes give some feedback on how much you've rotated the piece.
This is my first openscad project. I am looking for feedback. If you have any comments, hints or suggestions let me know.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!