Thingiverse
printrboard 90 degree
von pen25
1
Downloads
2
Likes
0
Makes
modified to make stronger. i removed the tabs to hold the board in and strengthened the sides and added the fan location. will add a top half with fan mount later. there is a 2mm step to allow a top to slide over the bottom and added the skp. this was imported off the original stl so it wook allot of work to clean up
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!