Printrbot Lasercut Print Bed

This design is for a Printrbot with threaded rods at the base, Y and X smooth rods, and a sq. heated bed. The design is ~10.5 in. by ~13 in.

There's also a design that is made up of 4 pieces which attach together with 8 short #6 bolts.

There are 2 pairs of 2 holes for the belt clamps.

There are 4 holes closest to the middle for mounting a x heated build plate.

The 4 holes closest to the outside are for the Y Bar Clamps.

02/17 Update: Made the Y-bar holes wider to allow for some slop in the distance between each of the bases.

02/19 Update: Corrected position of the belt clamps. The belt clamp needed to line up with the edge of the 608 bearings.

02/21 Update: Added length. Hot end doesn't line up with x smooth rods, so there needs to be extra length on the right or left side of the print bed. Also made the holes wider for #6 bolts.

03/01 update: adjusted position of belt clamps

03/09 update: rounded edges slightly

05/01 update: attached a design for a