Printrbot Simple 1405 Extruder Cable Bracket

We recently upgraded our Printrbot Simple 1405 to the XL version. Our printer was printing perfectly prior to the upgrade but after the upgrade we noticed that there was a lot of inconsistency in the Z direction (layers) of the prints (see image). We noticed this solely happened when the extruder was moving the the Y Direction. We were sure it wasn't a slicer (software problem) so we investigated what was different mechanically. We discovered that the cable routing for the extruder, hot end, and auto level sensor was occasionally being interfered with by the edges of the tall wooden XL upgrade panel (when the extruder was moving in the Y Direction). As a result we decided a solution would be to route these cables on the outside of the wooden panel. However, the built-in zip tie hole near the extruder no longer worked for our solution. So we designed this bracket (with zip tie holder) as a result. It allows for complete unrestricted range in the Y direction. This little bracket was a bi