Printrbot Simple Metal BLTouch Mount

This is a remix of a BLTouch mount for a Printrbot Simple Metal from slipjig's Printrbot Simple Metal Upgrades: https://www.thingiverse.com/thing:4543170

Slipjig's version was too long for my Simple Metal, probably because I still have the factory original hot end whereas slipjig has the upgrade Ubis 13S hot end.

The remix was done in Tinkercad and consisted of:
1) Shrank the entire piece in the Z direction by approx. 4mm
2) Increased the Z dimension of the side window to make it easier to fish the wires through, although I still had to remove the connector shells to fit them through.
3) Added threads to the top section to make it easier to get the nut on.

As with slipjig's version, you will need to cut off the round hoop that is used to mount the original inductive sensor.