Thingiverse
Printrbot z axis extender
di eth2222
1
Download
3
Likes
0
Makes
After adding insulation and glass to my print bed I found I had taken at least a half inch of my z axis out of commission! These extenders bump the threaded rods about a inch up, extending the axis back to normal. I think this may only work if your print bed is higher than the usual. You will have to drill out the holes to your desired size.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!