Thingiverse
Printrbot Z Axis Stabilizer
von Crispy001
84
Downloads
98
Likes
3
Makes
These Z stabilizers reduce the amount of Z wobble by providing additional support to the Z axis smooth rods. Additionally, they are fully compatible with my popular bed stabilizer upgrade found here: http://www.thingiverse.com/thing:43200
Works quite well too!
Designed and tested for a Printrbot LC, a Printrbot Plus version has also been made to accommodate 12mm rods, though it is untested. Please comment if it works for you!
The standard size is .25" thick and the low profile version is slightly thinner at .20". If your printing surface isn't raised by glass or leveling screws, use the low profile version.
Volume: .4 cubic inches
ABS Weight: .01 pounds
Works quite well too!
Designed and tested for a Printrbot LC, a Printrbot Plus version has also been made to accommodate 12mm rods, though it is untested. Please comment if it works for you!
The standard size is .25" thick and the low profile version is slightly thinner at .20". If your printing surface isn't raised by glass or leveling screws, use the low profile version.
Volume: .4 cubic inches
ABS Weight: .01 pounds
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
