Pro Micro 12 key Keypad
von Anfuny
1
Downloads
2
Likes
0
Makes
Only had to print the base with supports just because of the hole that fits the Arduino Pro Micro.
The switches should just snap right into the holes, I didn't have to file it down or anything after printing.
It's a tight fit but there's enough room to have the Arduino underneath the keycaps. I secured mine with hot glue but I'm sure there's a better way of doing it.
The screw holes are designed for 16mm M3 screws.
The switches should just snap right into the holes, I didn't have to file it down or anything after printing.
It's a tight fit but there's enough room to have the Arduino underneath the keycaps. I secured mine with hot glue but I'm sure there's a better way of doing it.
The screw holes are designed for 16mm M3 screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!