Thingiverse
project box for power switch
von struggle_bus
3
Downloads
0
Likes
0
Makes
so i needed a project box for an automotive on/off switch, and ~8 wires coming in and out.
5mm thick is likely overkill for the box.
holes should work for m3 8s or 10s (had to resize top cut outs)
was able to print both top and bottom without supports. not super quality for pics, but also old filament.
5mm thick is likely overkill for the box.
holes should work for m3 8s or 10s (had to resize top cut outs)
was able to print both top and bottom without supports. not super quality for pics, but also old filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
