Thingiverse
"Project Locus" - A Large 3D Printed, 3D Printer
von redhatman
466
Downloads
371
Likes
2
Makes
My former roommate and I went half and half on a Prusa i2 a year or two ago. After we decided we weren't living together again, we were faced with the question of who's going to keep the printer. I decided I wanted to create a larger printer, and long story short, this entire printer was created using that printer. Everything was designed by me. See the "Instructions" tab for a full build manual.
- The total build volume is roughly 1 cubic foot (12" x 12" x 12").
- The design challenges as well as a detailed overview of the printer can be found in the instructions.
- The total build volume is roughly 1 cubic foot (12" x 12" x 12").
- The design challenges as well as a detailed overview of the printer can be found in the instructions.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
