Thingiverse
Project Mat
von SirGed
24
Downloads
10
Likes
0
Makes
Printed with TPU, fits the bits from the iFixIt screwdriver kits. Prints wonderfully at about 30 mm/s and 240 degrees.
Next I probably need to enlarge the holes just a bit more as my TPU shrunk to where it is slightly too snug. Also want to try doing 1-2 layers of PLA or PETG then the TPU to add some rigidity.
Next I probably need to enlarge the holes just a bit more as my TPU shrunk to where it is slightly too snug. Also want to try doing 1-2 layers of PLA or PETG then the TPU to add some rigidity.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!