Thingiverse
Project Vacuboss - 7mm prototype
von SchizoDuckie
3
Downloads
4
Likes
0
Makes
My take on NFE's brilliant BOSS micro.
Place the motors in the motor holes of the frame, then vacuform the whole thing. Cut off excess and open up the top of the motors.
Designed in tinkercad, will get a do-over in fusion some time soon and more motor sizes.
Needs no supports, maybe a little bit of filing to get the tolerances right.
Use 7mm brushed motors for this version and a mullet modded fpv camera
Place the motors in the motor holes of the frame, then vacuform the whole thing. Cut off excess and open up the top of the motors.
Designed in tinkercad, will get a do-over in fusion some time soon and more motor sizes.
Needs no supports, maybe a little bit of filing to get the tolerances right.
Use 7mm brushed motors for this version and a mullet modded fpv camera
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
