Prometheus

Photo shows it on the side of my X1C. A two-parted filament painting, be sure to print both parts with following swaps, they will then fit perfectly: *** BE SURE TO SET SWAPS ON PLATE 2 MANUALLY *** *** EXPERIMENT WITH THE COLORS *** Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used: PLA BambuLab Matte Charcoal Transmission Distance: 0.6 PLA BambuLab Matte Dark Blue Transmission Distance: 1 PLA BambuLab Basic Orange Transmission Distance: 10 PLA BambuLab Matte Ivory White Transmission Distance: 4Swap Instructions: Start with Charcoal At layer #13 (1.12mm) swap to Dark Blue At layer #16 (1.36mm) swap to Orange At layer #27 (2.24mm) swap to Ivory White for the rest.