Thingiverse
Propagation Station
von MidnightMagpie
20
Downloads
39
Likes
0
Makes
Plant propagation kit for small cuttings.
\No supports needed if the holder if printed on its back.
The tube did have a brim for extra stability as it was printed upright.
Tubes will stand upright unaided.
You will need 2x lid prints as I have not yet designed an opening one. Maybe in future.
\No supports needed if the holder if printed on its back.
The tube did have a brim for extra stability as it was printed upright.
Tubes will stand upright unaided.
You will need 2x lid prints as I have not yet designed an opening one. Maybe in future.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
