Thingiverse
Proscenic P15 Wall Mount
door sc_tech
0
Downloads
0
Likes
0
Makes
Wall Mount for Proscenic P15 vacuum as previous model P11.
It can handle the weight of the complete vacuum and the accessories.
Secure the Mount: Use two screws to attach the wall bracket. It is built to hold the entire vacuum and its accessories.
Cable Integration: Thread the power connector through the bottom hole.
Lock the Connector: Slide the connector block into the mounting rails until it is firm and seated blocking completely in the right position the power supply connector
0,2mm layer height (3h20min)
0,28mm layer height (3h)
4 walls for extra strength
Infill Tri-Hexagon
print in PLA or PETG
support could be of the same model material. No problems in removing it
It can handle the weight of the complete vacuum and the accessories.
Secure the Mount: Use two screws to attach the wall bracket. It is built to hold the entire vacuum and its accessories.
Cable Integration: Thread the power connector through the bottom hole.
Lock the Connector: Slide the connector block into the mounting rails until it is firm and seated blocking completely in the right position the power supply connector
0,2mm layer height (3h20min)
0,28mm layer height (3h)
4 walls for extra strength
Infill Tri-Hexagon
print in PLA or PETG
support could be of the same model material. No problems in removing it
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!