Thingiverse
Engineering
Voir le modèle
Prosthetic Drumstick Holder
0
Téléchargements
3
Likes
0
Makes
This is an attachment for the octagonal adapter made by SPU Engineering, that allows a person who has lost a hand to hold a drumstick.
The Drumstick holder was also made by an SPU Engineering student.
- This takes roughly 2 hours to print.
- To use, slide a drumstick that is a little wider in diameter than 0.75 inches into the slot on the print, and attach the octagonal adapter to the octagonal mount made by SPU.
- I used a "Vic Firth Corpsmaster Signature Snare Stick - Ralph Hardimon Wooden Tip" wrapped in white electrical tape for this project.
The Drumstick holder was also made by an SPU Engineering student.
- This takes roughly 2 hours to print.
- To use, slide a drumstick that is a little wider in diameter than 0.75 inches into the slot on the print, and attach the octagonal adapter to the octagonal mount made by SPU.
- I used a "Vic Firth Corpsmaster Signature Snare Stick - Ralph Hardimon Wooden Tip" wrapped in white electrical tape for this project.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
