Thingiverse
Protective Face Shield x 2
von dcotelessa
3
Downloads
1
Likes
0
Makes
This a remix of this print:
https://www.matterhackers.com/store/l/protective-face-shield/sk/M7LP9Q7M?fbclid=IwAR1KKWhi35VwhQSRfbmSJLaUi22RG2b1GMa5ZEyo430fRQj3XErZOxKjuic
I modded to use less filament by thinning the area of the hooks. This also helps with printing. This loses the advantages of having it be stackable, but the tradeoff seemed worthwhile.
I modded one of the hooks to fit two shields around each other. It also helps with orientation of the shield.
The print area for these print JUST under 200mm x 200mm, therefore there should be plenty of space on my Ender 5 but it theoretically can print on a smaller 3-d printer.
The two shields print under 35 minutes using 0.8 nozzle.
I used PLA for speediest print. I will add as much as I can later. Any advice to improve welcome.
https://www.matterhackers.com/store/l/protective-face-shield/sk/M7LP9Q7M?fbclid=IwAR1KKWhi35VwhQSRfbmSJLaUi22RG2b1GMa5ZEyo430fRQj3XErZOxKjuic
I modded to use less filament by thinning the area of the hooks. This also helps with printing. This loses the advantages of having it be stackable, but the tradeoff seemed worthwhile.
I modded one of the hooks to fit two shields around each other. It also helps with orientation of the shield.
The print area for these print JUST under 200mm x 200mm, therefore there should be plenty of space on my Ender 5 but it theoretically can print on a smaller 3-d printer.
The two shields print under 35 minutes using 0.8 nozzle.
I used PLA for speediest print. I will add as much as I can later. Any advice to improve welcome.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
