Thingiverse
Electronics
Model downloaden
Protective Switch Cover
150
Downloads
98
Likes
1
Makes
This is a cover for a switch or button so that it is not accidentally pressed or turned on.
The switch pictured above was printed on a Makerbot Replicator 2 in standard (0.20mm layer height) with 10% infill. The hinge is made from 4-40 machine screws, and although the holes were designed to be free fit, there is a slight bit of thread engagement as the screws go through the hinges.
This was designed in Solidworks 2014.
Enjoy!
The switch pictured above was printed on a Makerbot Replicator 2 in standard (0.20mm layer height) with 10% infill. The hinge is made from 4-40 machine screws, and although the holes were designed to be free fit, there is a slight bit of thread engagement as the screws go through the hinges.
This was designed in Solidworks 2014.
Enjoy!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
