Cults3D
Tool
Ver Modelo
Protective Wire Guide Bracket
0
Descargas
0
Likes
0
Makes
This is a very simple protective wire-guide bracket is intended to allow a wire to pass over the edge of a roof or awning without rubbing or chafing. A through-hole enables a zip-tie to "lock" the wire into the guide tube.
**If you use these outdoors, make sure you print them out of PETG or some other weather-resistant filament.**
This wire guide uses no special slicer settings and can be printed without supports.
There are 3 variations included; the regular standoff, a slightly shorter version, and an alternate mounting model.
This design is nothing fancy but it works well for me to protect some wires from a solar panel from rubbing or contacting the edge of a metal awning.
Feel free to mix/remix/redesign to suit your needs!
**If you use these outdoors, make sure you print them out of PETG or some other weather-resistant filament.**
This wire guide uses no special slicer settings and can be printed without supports.
There are 3 variations included; the regular standoff, a slightly shorter version, and an alternate mounting model.
This design is nothing fancy but it works well for me to protect some wires from a solar panel from rubbing or contacting the edge of a metal awning.
Feel free to mix/remix/redesign to suit your needs!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
