Thingiverse
Proteus Respirator
door ProteanMan
117
Downloads
84
Likes
1
Makes
Proteus Respirator
**Updated May 4th: Found the 100-130 & 100-140 threads to be left handed on one side, those are now fixed. Thank you Ives for pointing that out. May the 4th be with you!
**Updated April 12th: adjusted nose area width to be better printable, Adjusted chin area to a more rounded and fitted structure**
*Designed for comfort and ease of use*
*This does not replace an approved medical grade mask*
The goal of this was to design a mask that is easy to use, comfortable, and to create as little waste as possible. The only thing you should need to replace is the filter, which can be created from common household supplies (see below).
**Sizing (Height-Width)**
Please print the "Face_Size_Tester" and use the image supplied above to measure your face for the proper mask. This is to ensure the best seal as possible.
*you will most likely need to glue fabric or foam inside the mask to seal it properly, printing the proper size for your face is very important as a first
**Updated May 4th: Found the 100-130 & 100-140 threads to be left handed on one side, those are now fixed. Thank you Ives for pointing that out. May the 4th be with you!
**Updated April 12th: adjusted nose area width to be better printable, Adjusted chin area to a more rounded and fitted structure**
*Designed for comfort and ease of use*
*This does not replace an approved medical grade mask*
The goal of this was to design a mask that is easy to use, comfortable, and to create as little waste as possible. The only thing you should need to replace is the filter, which can be created from common household supplies (see below).
**Sizing (Height-Width)**
Please print the "Face_Size_Tester" and use the image supplied above to measure your face for the proper mask. This is to ensure the best seal as possible.
*you will most likely need to glue fabric or foam inside the mask to seal it properly, printing the proper size for your face is very important as a first
ProteanMan publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
