Thingiverse
Proto-X Case
by Bsand1215
66
Downloads
35
Likes
1
Makes
Simply run the axle through the holes in the lid and case and you're good to go. I recommend gluing the axle to the lid once its in to prevent it falling out.
Everything fits within the case, including the controller, charging wire, and quadcopter. The controller must be slightly angled to fit properly in the slot.
Printed with 10% infill to save on plastic and still holds very sturdy
Everything fits within the case, including the controller, charging wire, and quadcopter. The controller must be slightly angled to fit properly in the slot.
Printed with 10% infill to save on plastic and still holds very sturdy
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
