Thingiverse
Proton Pack Shock Mount
von tgoacher
73
Downloads
36
Likes
0
Makes
A full size, 3D printable version of the shock mount on the Ghostbusters proton pack.
Based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/File:Stefan%27s_Proton_Pack_Plans_Page_14.jpg
There are other versions of this on Thingiverse, but I have found that they do not print very well.
Print two copies of shock1.stl and one of shock2.stl. Glue all the sock1 plates and the shock2 plate with the hole together, and hold in place with a threaded bar clamped with nuts to set.
Finally glue in place the cap without the hole,
Based on Steffan Otto's plans at:
http://www.gbfans.com/wiki/File:Stefan%27s_Proton_Pack_Plans_Page_14.jpg
There are other versions of this on Thingiverse, but I have found that they do not print very well.
Print two copies of shock1.stl and one of shock2.stl. Glue all the sock1 plates and the shock2 plate with the hole together, and hold in place with a threaded bar clamped with nuts to set.
Finally glue in place the cap without the hole,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
