Thingiverse
Protoss Pylon Starcraft
door kerthg
110
Downloads
83
Likes
0
Makes
Scanned in the thinkgeek Protoss Pylon usb charger with a Makerbot Digitizer. This is the best I could get with it. Prints out pretty well. I'd recommend cutting off about 2mm off the bottom as the points were difficult to print for me because so little touched the print bed.
May print better cut in half then two halves glued instead of using supports.
May print better cut in half then two halves glued instead of using supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!