Thingiverse
Provap case
von Michi1234
0
Downloads
2
Likes
0
Makes
This is a replacement case for the Provap220. The original is glued and can´t open without destroing it. There are no Supports needed.
Also 4 m5x30mm srcews are needed to close the case. I´ve taped threads in the holes at the bottom by a tool.
Also 4 m5x30mm srcews are needed to close the case. I´ve taped threads in the holes at the bottom by a tool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!