Thingiverse
Provisional Bridge Test
von doyundoyun
4
Downloads
0
Likes
0
Makes
4-unit bridge and four abutment model are attached.
The offset between the crown and the abutment is 30um.
You can print the bridge and check the adaptation into the abutments.
Print the bridge with a provisional resin and the abutment model with a model resin.
The offset between the crown and the abutment is 30um.
You can print the bridge and check the adaptation into the abutments.
Print the bridge with a provisional resin and the abutment model with a model resin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
