Proximity Sensor Slider

This part is designed to allow you to adjust the position of the proximity sensor on the Reach 3D printer. Tried it out last night and it works, took 3 tries to get the filament to stick correctly. There are two parts to print, use the wood screw from the original kit to clamp the part to the sensor. You will need a M3x40mm screw, two M3 nuts and a washer. See the photos for assembly.

You will need to flip the Clamp Holder when printing so the flat is on the bed.

(August 8th edit: the clamp_holder has been updated with the new hole location)