Thingiverse
Proxmark3 RDV3(easy) Case
door paleopterix
5
Downloads
8
Likes
0
Makes
3D printable case for our wonderful Proxmark3...
Nozzle Size 0.3, Layer height 0.2, 10% Infil.
If the tolerance of the part is too small (and the proxmark board doesn't fit) you can always apply some scaling along X-Y or Z
The "top" part must be printed with support. I used the default "Grid" support option in Cura Slicer, with 10% fill amount, 2mm XY-distance and 0.2mm Z-distance. The support can be removed afterwards, using some pliers and a cutter.
Fastening the case will require one M3 screw (screws directly into the plastic).
Nozzle Size 0.3, Layer height 0.2, 10% Infil.
If the tolerance of the part is too small (and the proxmark board doesn't fit) you can always apply some scaling along X-Y or Z
The "top" part must be printed with support. I used the default "Grid" support option in Cura Slicer, with 10% fill amount, 2mm XY-distance and 0.2mm Z-distance. The support can be removed afterwards, using some pliers and a cutter.
Fastening the case will require one M3 screw (screws directly into the plastic).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
