Thingiverse
Proxxon MF70 Alignment assistant
by robwhi
179
Downloads
100
Likes
0
Makes
Little assistants to help align stuff on the PROXXON MF70 micro mill (and presumably the standalone X-Y table by the same manufacturer).
The slot is 6mm and the hole 6mm.
UPDATE 29.3.2015:
I made one out of aluminium. I used a 3mm end mill so the inside corner has a radius. The stock I had was 5 mm thick, so that determined the height of the piece.
I have used the plastic ones successfully. They are good for aligning your stock on the xy table of your mill so that you can get the most out of your stock.
The slot is 6mm and the hole 6mm.
UPDATE 29.3.2015:
I made one out of aluminium. I used a 3mm end mill so the inside corner has a radius. The stock I had was 5 mm thick, so that determined the height of the piece.
I have used the plastic ones successfully. They are good for aligning your stock on the xy table of your mill so that you can get the most out of your stock.
robwhi also publishes on
32 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
