Thingiverse
Prusa Bear LED Bar
door jamestaylorjames
24
Downloads
11
Likes
0
Makes
Remix of LED Bar by SethBon to fit Bear frame. Attaches to top of frame using tapped holes and M5 screws. replacing the z end caps. There is a small hole either side for wiring depending on which side you wish to route wires.
Uses same aluminium channel as other design cut too 310MM.
Second file is a mount for a switch.
Use original guide for wiring instructions.
Uses same aluminium channel as other design cut too 310MM.
Second file is a mount for a switch.
Use original guide for wiring instructions.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!