Prusa Core One Wiper

With some technical filaments i had sometimes the problem that the printer will fail at the Cleaning Nozzle stage due to the oozing or harder materials. Solutions like drying filament did not work out. As a lot of other printers using a wiper to get rid of all nozzle debris i created a wiper which attaches to the bed holder. Its using the brushes from the BL A1 as they are super cheap to get from aliexpress/amazon. Warning: You will loose 1mm of Y Travel at the X location of the brush due to the part cooling fan.As this was designed very quick and dirty there is for sure a way to get full travel. Possible Remixes? :-) Hardware needed.M3x8 ScrewA1 silicone WiperPrinted partInstall:Put the silicone on the printed partScrew the wiper on the bed holder (see picture). You just screw it into the plastic. .step file attached if you want to use a heat insertChange Slicer Start G-codefrom:G29 P9 X208 Y-2.5 W32 H4to:;G29 P9 X208 Y-2.5 W32 H4 ; original nozzle cleaning method G0 X40 Y-14 Z2.5 F10