Thingiverse
Prusa filament button
door Bearzilla
63
Downloads
25
Likes
1
Makes
My girlfriend found it difficult changing filament as the springs cut into her hand, so I designed & printed this in a couple of minutes to make it easier.
The holes on the button are a tight fit, I had to heat up the holes with a lighter for a few seconds before sliding it on.
Though it might help someone else!
The holes on the button are a tight fit, I had to heat up the holes with a lighter for a few seconds before sliding it on.
Though it might help someone else!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!