Thingiverse
Prusa i2 Side Power
by jfornango
2
Downloads
4
Likes
0
Makes
I've seen a lot of good power and switch panels, but none that would fit the front or back of my particular setup. Since I have lots of room on the side rails, I figured that's a good place to put it all.
The mount holes are slightly undersized, with no screw holes, to accommodate several different styles of plug and switch. It took me less than 10 minutes with a Dremel to fit my particular parts.
The mount holes are slightly undersized, with no screw holes, to accommodate several different styles of plug and switch. It took me less than 10 minutes with a Dremel to fit my particular parts.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
