Thingiverse
Prusa I3 - 8mm Threaded Rod Anchor - Split
door 3dprintsolutions
4
Downloads
4
Likes
0
Makes
Prusa I3 - 8mm Threaded Rod Anchor Lock Down Mounts.
If you want to lock your I3 down to a Flat piece of Timber/Melamine, then you can use these simple little Lock Downs
BOM:
1 - 3mm Cup Head @ 25mm Long
1 - 3mm Nut
1 - 3mm lock washer
Wood screws to suit for Locking to board {small whatever you have handy}
Approx 14mm Long
I put 4 holes in for Locking Screws, but 2 would be plenty, (Diagonally opposite would be best)
Update: 10mm variety here
http://www.thingiverse.com/thing:1137115
If you want to lock your I3 down to a Flat piece of Timber/Melamine, then you can use these simple little Lock Downs
BOM:
1 - 3mm Cup Head @ 25mm Long
1 - 3mm Nut
1 - 3mm lock washer
Wood screws to suit for Locking to board {small whatever you have handy}
Approx 14mm Long
I put 4 holes in for Locking Screws, but 2 would be plenty, (Diagonally opposite would be best)
Update: 10mm variety here
http://www.thingiverse.com/thing:1137115
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
