Prusa i3 E-Bear Printer

Ebear
**Goal:**
I wanted to build a very high quality printer without spending a lot (350 or so). It uses pekcitron's (Gregoire) bear x axis ends but modified (by Toolson) to fit commonly sourced lead screw, The other type were too hard for me to get a hold of during the covid pandemic. Also includes mounts for regular end stops and conventional glass and PCB bed on a pretty cheap Y carriage, which I feel has been pretty effective up to about 90C,
**BOM:**
Note:
If you have these parts, as many of us do, it could save significant amounts
_Ideas on where to cut corners_
I reused old stepper motors, I found I had had some extra new lead screws, hot end, fans, heated bed, and belt material from previous builds since most those parts come in bulk. Here is a vague breakdown, and you can probably find all these cheaper somewhere, I took the Amazon and quickest possible to ship on a lot of these prices.
You could also do this build with any cheap RAMPS setup that you have teste