Thingiverse
Prusa i3 MK3 Raspberry Camera Mount
door trinxie
33
Downloads
16
Likes
0
Makes
Raspberry Pi Camera mount for Prusa i3 MK3.
I use ti for Octoprint and Raspberry Pi Camera module v2.
Inspired by https://www.thingiverse.com/thing:1646474 and https://www.thingiverse.com/thing:2736439, but I wanted a more flexible mount as I have the printer in an enclosure with limited space in Y direction. I redesigned the camera case to have the flexibility for designing the tolerance for the ball mount.
If the arm tolerance gets too big, you can mount M4 screws and a nuts as i my pictures.
I also created a simple mount for my PI case, will also need two M4 screws and nuts. The nut holder (MK3Pi_AluMount.stl) is easiest to mount if you have the screw in place and then rotate the nutholder 90 degrees in the aluminum extrude.
When mounting the arm (MK3Pi_Y-Mount.stl) to the Y axis, you press it in with a slight upward angle. You can mount a zip-tie, but found that it was not needed.
I use ti for Octoprint and Raspberry Pi Camera module v2.
Inspired by https://www.thingiverse.com/thing:1646474 and https://www.thingiverse.com/thing:2736439, but I wanted a more flexible mount as I have the printer in an enclosure with limited space in Y direction. I redesigned the camera case to have the flexibility for designing the tolerance for the ball mount.
If the arm tolerance gets too big, you can mount M4 screws and a nuts as i my pictures.
I also created a simple mount for my PI case, will also need two M4 screws and nuts. The nut holder (MK3Pi_AluMount.stl) is easiest to mount if you have the screw in place and then rotate the nutholder 90 degrees in the aluminum extrude.
When mounting the arm (MK3Pi_Y-Mount.stl) to the Y axis, you press it in with a slight upward angle. You can mount a zip-tie, but found that it was not needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
