Prusa i3 Mk3 Toolboxes

Since I built the Prusa it felt like it had potential on both sides to add some storage room for the tools you need when printing models.

jgm1986's flat cable clip was the starting point I was looking for, as I imagined the 2020 alu profile of the printer's base would be a great fixing point for my boxes without the need of screws or metal clips.

I wanted the boxes to be modular/expandable, so halfway, there are some notches that allow you to put on a second level or a lid. In my case I already designed an inlay for storing Superglue, misc. small parts and some nozzles (Remix from StasPimenov; if it does not fit: sand the edges slightly), .
Integrating a remix of Lalo_Solo's USB/SD card holder seemed logical, allowing just enough space on the left side to remove the printer's SD-card.
The right box has a holder for a caliper on the side.

The only thing you need to keep in mind is that the storage room resides partly under the moving printing bed. So don't overfill the boxes