Thingiverse

PRUSA i3 MK3S

von 3DPrinting_at_Home

10 Downloads

5 Likes

1 Makes

Based on an inspiration from PrusaPrinters community I had to redesign my personal PRUSA i3 MK3S Tool Holder.

Reason: 6 mm to short, no good spport on power supply, to flexible, worn tools.

Original Prusa Tool Holder:
https://www.prusaprinters.org/prints/37057-prusa-tool-holder-upgraded

Holder organize a:
- Knipex Side cutter
- Knipex Gripper
- Palette Knife / Scraper
- Inbus
- Nozzle Brush
- 3 SD-Cards

All was printed by:
- 0,2 mm layer height
- Prusament PTEG - Prusa orange
- NO Support need

holder knipex nozzle brush no support needed organizer Original Prusa i3 MK3 prusa prusa i3 mk3 scaper SD-Card tool tool holder holder knipex nozzle brush no support needed organizer Original Prusa i3 MK3 prusa prusa i3 mk3 scaper SD-Card tool tool holder

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

PRUSA i3 MK3S

Ähnliche Modelle

Zur Sammlung hinzufügen