Thingiverse
Prusa I3 X endstop mount
door Raloszekk
88
Downloads
25
Likes
4
Makes
- Made for the FolgerTech variant of the Prusa I3 but I'm sure it can be used for most Prusas
- Two mounting holes are 3.25mm and are 20mm apart from center
- Mounting clips are based off two 8mm linear rods that or 45mm apart from center or 37mm apart from the edge.
- Only use if you have the same end stop shown in my picture.
- Two mounting holes are 3.25mm and are 20mm apart from center
- Mounting clips are based off two 8mm linear rods that or 45mm apart from center or 37mm apart from the edge.
- Only use if you have the same end stop shown in my picture.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
