Prusa Lack Enclosure

These corners are used to connect a third Lack table to the Prusa Lack Enclosure. (Otherwise, the top two tables could easily slide off the lowest table.) They are the same as the original corners, except the unnecessary hinges and plexiglass supports have been removed.

The lower corner is screwed to the bottom of each leg, and the upper corner is screwed to the top of the table in the four corners.

Just like the original parts, although they are not a remix because I modeled them in Fusion 360 from scratch. My compliments to Josef Průša, his awesome company, and the original designer of these parts.

Each unit is attached with a 6×20 mm screw (or 3/4" #14 wood screw).