Thingiverse

Prusa Light Holder

von AdamsThings

10 Downloads

1 Likes

0 Makes

This is a mount made to hold a ring light on the cross bar of a Prusa MK3S. This model uses three parts (1) Clip, (2) PreasureNut, (3) BoltKnob (if you use a common 1/4 20 hex bolt) or (3) BoltPrinted (if you dont have a 1/4 20 bolt laying around). Simply clip the CLIP onto the top bar then thread the bolt into what ever accessory you intend to use (I used a ring light but a 1/4 20 bolt also works for a GoPro mount if you wanted a top down recording. Then thread on the PREASURENUT before mounting the accessory. Lasty, mount the accessory and tighten the PREASURENUT against the accessory to secure it.

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig Hardware nötig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat