Prusa Mini leg leveler

Allows for the independent adjustment of each corner of the Prusa Mini.

I have my Prusa Mini in my garage and the floor is tilted at an angle. To address this, I needed to adjust the level of each corner independently. At first, I used a bunch of shims but, it was ugly and not fool proof. That's why I figured I can print what I needed.

The files have been created to to allow for the stock foam feet that come from Prusa to fit in perfectly. You must, however, adjust the the height of each object to make sure it's right for your situation. **Do not** adjust the other dimensions because you will skew the hole for the feet.

Since the rear right corner also needs to support the circuit board, etc. it needs a separate file with different dimensions.

When figuring out the height you need, take into account the foam feet. The depth of the insert is 0.8mm

This has 2 STL files:
* **prusa mini leveler.stl** : This file should be adjusted to accommodate all corners except for the r