Thingiverse
Prusa Mini - Z Axis Windmill
von NumptyMan
10
Downloads
5
Likes
0
Makes
Just a quick design to make a Z Axis flag, to show the live bed levelling is working.
Simple design that flat on sheet but looks ok in use.
Use a Neodymium Round Cylinder Magnet 8X3mm (Amazon). It's a tight push fit which does bulge out the body a tiny bit, but should still fit in the top of the Z motor.
Simple design that flat on sheet but looks ok in use.
Use a Neodymium Round Cylinder Magnet 8X3mm (Amazon). It's a tight push fit which does bulge out the body a tiny bit, but should still fit in the top of the Z motor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!