Thingiverse
Prusa MMU Mini Buffer - Version 1
von Steveps3
114
Downloads
65
Likes
0
Makes
The Prusa MMU buffer has never really struck me as being very practical. So I decided to design my own. After several iterations I came up with the mini buffer. Just connect it to the end of your MMU PTFE tube (using a bowden connector) and the filament just unspools into a loop. When the filament is required again it simple spools back in. No need for auto rewinding spool holders etc.
Optionally you can use 2 lengths of PTFE tubing if you feel that the filament is not feeding correctly without it.
You'll need a bowden connector and a 608 bearing which goes between the two halves of the wheel.
Optionally you can use 2 lengths of PTFE tubing if you feel that the filament is not feeding correctly without it.
You'll need a bowden connector and a 608 bearing which goes between the two halves of the wheel.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
