Prusa Original Enclosure LED Strips Mod For Basic Control Board

Having several Prusa Enclosures, it can get very expensive to add the official Prusa LEDs, given they'll currently only work on white.So do this instead for ~3.50 GBP per machine, and have it work perfectly with your Prusa Basic Control Box.Materials you'll need:Pre-made Molex Clickmate 5CKT cables. Mouser part 538-15135-0503. You'll need one cable per two LED strips (we cut them in half to use each end) - 1.11 each strip (2.22 for two ends)24V COB LED Strip - 6000k white, high CRI for best visibility. I bought 10m off Amazon for 22 (ASIN: B0BVVZMTQ3). These are very high density, diffused LEDs. You will need roughly 0.5m / 50cm per Prusa, 1.10 each.Some wire to extend the cable slightly. Anything around 28AWG will work perfectly.A few bits of heatshrink to cover the solder joints.The steps you'll need to take:Cut the cable extensions in half to create two terminated leads.Clip off the leads from Pin 3,4,5 (Right 3 pins when looking at the plugged in board.Strip the end