Thingiverse
Prusa Overhead LED Light Bars
von esotericmaker
12
Downloads
10
Likes
0
Makes
Dual Overhead LED light bars for Prusa MK3s printer.
Standard (non-waterproof) LED strips slide into the light bars and the assembly clips onto the Prusa horizontal overhead frame bar.
You can use 2 10" 12v strips (15 LEDs each) and wire them in SERIES so that the total voltage across them is 24v which allows you to connect them directly to the 24v Prusa power supply.
UPDATED to ver2 (6/7/22)
-- Better clasp attachment
-- Wiring holes on R. side (Power supply end) only
-- Extended LED visibility at ends
Standard (non-waterproof) LED strips slide into the light bars and the assembly clips onto the Prusa horizontal overhead frame bar.
You can use 2 10" 12v strips (15 LEDs each) and wire them in SERIES so that the total voltage across them is 24v which allows you to connect them directly to the 24v Prusa power supply.
UPDATED to ver2 (6/7/22)
-- Better clasp attachment
-- Wiring holes on R. side (Power supply end) only
-- Extended LED visibility at ends
esotericmaker veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
