Prusa Pipe Enclosure

A simple frame for an enclosure to be placed on an IKEA Lack table.

It consists of eight printed corner pieces:
- 1 x Front-Right-Lower
- 1 x Front-Left-Lower
- 2 x Back-Lower
- 4 x Upper-Corner

and some pipes with outside diameter 16mm cut to matching length.

for this to place on an IKEA Lack table you need:
- 3 x 51 cm on the bottom
- 4 x 51 cm on the top
- 4 x about 51+ cm to set the hight (I used 54cm to leave some room for a MMU2 in the future)

to be done:
- hinges for some doors
- strong magnets and plexiglas