PS2 Controller Port Sleeve Replacment

####This is a replacement part if your PS2 controller port sleeve broke off like mine did.

###Disclaimer:
This part is not perfect! You may need to resize or sand off excess material to fit.

###Printing:

This is a very small part with thin walls, so the the smaller the layer size, the better.
Also put the infill at 100%, as this part is too small for anything lower.
#####You can use PrusaSlicer's "variable layer height" to help speed up the print.

###After Printing:
1. Unless your sleeve broke off cleanly, I recommend breaking the pieces off and sanding them down individually as needed to fit.

2. Put on at a upper or downward angle for easy installation.

3. Lastly, when sliding it on be sure to have the flat bottom part go first. As the hole there is a bit wider on purpose.