Thingiverse
PS2 Slim 2 Vertical Stand
por TheJeffChen
30
Descargas
36
Likes
0
Makes
Vertical stand for the PS2 Slim 2 (SCPH-9000X). It's also compatible with the Slim 1 but wouldn't it be better to use [the correct one](https://www.thingiverse.com/thing:4822790) for authenticity?
The shape resembles the official design. However this is a vase design in order to cut down print time.
There are two designs. One is single-piece open end, since no one is going to be looking at the back of the stand. The other has an end cap to close up the shape.
Printing the main piece with either end facing down WITHOUT support is ok (I've accounted for the issue).
End cap should be ok even if printed facing up if your enable support and the tolerance is dialed in fine. Otherwise, print with the flat exterior face facing down.
Rubber feet of diameter up to 11mm are recommended for the grooves facing down towards the table and up towards the console.
For side gripping, there are slots for you to fit some tape (either electric or automotive) as well as rubber feet (if you
The shape resembles the official design. However this is a vase design in order to cut down print time.
There are two designs. One is single-piece open end, since no one is going to be looking at the back of the stand. The other has an end cap to close up the shape.
Printing the main piece with either end facing down WITHOUT support is ok (I've accounted for the issue).
End cap should be ok even if printed facing up if your enable support and the tolerance is dialed in fine. Otherwise, print with the flat exterior face facing down.
Rubber feet of diameter up to 11mm are recommended for the grooves facing down towards the table and up towards the console.
For side gripping, there are slots for you to fit some tape (either electric or automotive) as well as rubber feet (if you
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
