MakerWorld
Organizers
Ver Modelo
PS5 Wall holder
7
Descargas
5
Likes
4
Makes
I designed a simple PS5 controller holder for the wall - I added an optional option to run the charging cable through the back wall from all 4 sides (it's up to you which route you choose and which one will suit you)I printed the holder from PETG because I like its stiffness and shine the most, but it's up to you how you print it, PLA works well too.Printing without supports works very well - see my photos - even if the slicer can try to convince you to use supports, they are not needed at all - all the places where this can be seen are on the back side, which is not visible.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!