Thingiverse
PSU case
por digimatic
397
Descargas
278
Likes
1
Makes
Thick walled case for equipment PSU's
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!